Perform the following binary subtractions of unsigned binary numbers.

Perform the following binary subtractions of unsigned binary numbers. Convert your answer to decimal.
i) 101001012 – 010010012 ii) 110110102 – 100100112
b) Repeat the calculations above but for when the binary numbers are in two’s complement form. Comment on the results of the two methods used, noting and discrepancies.
2. Find the sums of the following unsigned hexadecimal numbers. Indicate whether or not the sum overflows an equivalent 8-bit binary result.
a) 1116 + 2216 b) 1716 + 3516 c) FA16 + CE16 d) BA16+ A1316
3. Shown below are the contents of a 16-bit resister. Determine the decimal value represented by the binary number if:
a) the binary number is unsigned b) the binary number is in two ‘s complement form.

find the cost of your paper

design suitable bearings to support the load for at least 5E8 cycles at 1 200 rpm using deepgroove ball bearings.

The shaft shown in Figure P11-4 was designed in Problem 10-19. For the data in row (a) of Table P11-1, and the corresponding diameter of shaft found in Problem 10-19,….

Find the minimum film thickness for a long bearing with the following data: 30-mm dia, 130 mm long, 0.0015 clearance ratio, 1 500 rpm, ISO VG 100 oil at 200°F, and supporting a load of 7 kN.

1.       A paper machine processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50-m OD X 22-cm ID X 3.23-m long and is on a simply supported, 22-cm OD, steel….

Find the minimum film thickness for a bearing with these data: 30-mm dia, 25 mm long, 0.0015 clearance ratio, 1 500 rpm, ON = 30, ISO VG 220 oil at 200°F.

1.       Problem 7-12 estimated the volume of adhesive wear to expect from a steel shaft of 40 mm dia rotating at 250 rpm for 10 years in a plain bronze….