explain if there is any discrepancy between the calculated and simulated results.

Overhead And Underground Power Line Design (NNM6003) Laboratory-1Transmission line modeling utilizing MATLAB/SimulinkTask 1: Model and simulate the above short transmission network in Matlab/Simulink and verify the voltage and power at the sending and receiving end with the calculated results in Lab1_material_1. Also, explain if there is any discrepancy between the calculated and simulated results. You need the following components- 1. Three-Phase Source2. Three-Phase load3. For short transmission line, you don’t need capacitance hence you can use ThreePhase Series RL Branch for this4. RMS block5. 3ph, instantaneous power calculation6. Insert powergui and continuous in the model to run the model7. Display blockTask 2: Model and simulate the above long transmission network in Matlab/Simulink and verify the voltage and power at the sending and receiving end with the calculated results inLab1_material_2. You need the following components- 1. Three-Phase Source2. Three-Phase load3. For lossless long transmission line, you don’t need resistance hence you can use Three-Phase Series RL Branch for this4. Numbers 4-7 in Task 1You must add all the relevant display results in parallel to the calculated results. Also, explain if there is any discrepancy between the calculated and simulated results.

find the cost of your paper

design suitable bearings to support the load for at least 5E8 cycles at 1 200 rpm using deepgroove ball bearings.

The shaft shown in Figure P11-4 was designed in Problem 10-19. For the data in row (a) of Table P11-1, and the corresponding diameter of shaft found in Problem 10-19,….

Find the minimum film thickness for a long bearing with the following data: 30-mm dia, 130 mm long, 0.0015 clearance ratio, 1 500 rpm, ISO VG 100 oil at 200°F, and supporting a load of 7 kN.

1.       A paper machine processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50-m OD X 22-cm ID X 3.23-m long and is on a simply supported, 22-cm OD, steel….

Find the minimum film thickness for a bearing with these data: 30-mm dia, 25 mm long, 0.0015 clearance ratio, 1 500 rpm, ON = 30, ISO VG 220 oil at 200°F.

1.       Problem 7-12 estimated the volume of adhesive wear to expect from a steel shaft of 40 mm dia rotating at 250 rpm for 10 years in a plain bronze….