determine the heatinteractions Q12 and Q31.5. A gas undergoes a thermodynamic cycle consisting of the following process:i.Process1-2: Constant pressure p1=1.4 bar, V1= 0.028m3,W1-2=10.5kJ,ii.Process2-3: Compression with pV=C, U3=U2 and,iii.Process 3-1: Constant volume, U1-U3= -26.4kJ. There is no significant change in KE

4. A gas undergoes a thermodynamic cycle consisting of three process beginning at an initialstate where p1=1 bar, V1=1.5 m3 and U1=512 kJ. The process are follows:i.Process 1-2: Compression with pv=C to p2=2 bar and U2=690 kJ.ii.Process 2-3: W23=0, Q23= -150kJ andiii.Process 3-1: W31=+50 kJ. Neglecting KE and PE changes, determine the heatinteractions Q12 and Q31.5. A gas undergoes a thermodynamic cycle consisting of the following process:i.Process1-2: Constant pressure p1=1.4 bar, V1= 0.028m3,W1-2=10.5kJ,ii.Process2-3: Compression with pV=C, U3=U2 and,iii.Process 3-1: Constant volume, U1-U3= -26.4kJ. There is no significant change in KE

find the cost of your paper

design suitable bearings to support the load for at least 5E8 cycles at 1 200 rpm using deepgroove ball bearings.

The shaft shown in Figure P11-4 was designed in Problem 10-19. For the data in row (a) of Table P11-1, and the corresponding diameter of shaft found in Problem 10-19,….

Find the minimum film thickness for a long bearing with the following data: 30-mm dia, 130 mm long, 0.0015 clearance ratio, 1 500 rpm, ISO VG 100 oil at 200°F, and supporting a load of 7 kN.

1.       A paper machine processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50-m OD X 22-cm ID X 3.23-m long and is on a simply supported, 22-cm OD, steel….

Find the minimum film thickness for a bearing with these data: 30-mm dia, 25 mm long, 0.0015 clearance ratio, 1 500 rpm, ON = 30, ISO VG 220 oil at 200°F.

1.       Problem 7-12 estimated the volume of adhesive wear to expect from a steel shaft of 40 mm dia rotating at 250 rpm for 10 years in a plain bronze….