Determine Allowable Shear Force (3 points) Select value of Vn/f2v from AISC Steel Construction Manual Table 3-2 and compare with maximum applied Shear Force

The attached sketch shows the Roof Framing Plan of a Proposed Commercial Building with a DEAD LOAD of 60 psf and a LIVE LOAD of 120 psf
1. Assuming that the compression flanges of Roof Beams RB1 and RB2 have full lateral support:
a) Select the least-weight wide flange member for Roof Beam RBI (assume self-weight of 30 p11). Check Live Load Deflection. (4 points) b) Select the least-weight wide flange member for Roof Beam RB2 (assume self-weight of 40 pit). Check Live Load Deflection. (4 points) Note: Live Load Deflection shall not exceed 1/360 of Span Length
2. a) Determine the Maximum Moment (Mmax) and Maximum Shear Force (Vmax) acting on Roof Girder RG3 (2 points)
b) Assuming that the compression flange of Roof Girder RG3 is laterally supported at the supports and at 10ft intervals only (Lb =10ft) determine if a proposed W24x68 section is adequate to carry the loads acting on RG3
i) Determine Allowable Moment from the Lateral —Torsional Buckling Equation Mn/fib = Cb (Mp/S2b — BF/Sh(Lb-Lp)) (7 points) where Cb=1 .0
Select values of Mp/flb , BF/ 2b, 1,, from AISC Steel Construction Manual Table 3-2
(ii) Determine Allowable Shear Force (3 points) Select value of Vn/f2v from AISC Steel Construction Manual Table 3-2 and compare with maximum applied Shear Force
Assume Minimum Yield Strength of Steel is 50 ksi Safety Factor for Bending Gb = 1.67 Safety Factor against Shear Failure tin = 1.50

find the cost of your paper

design suitable bearings to support the load for at least 5E8 cycles at 1 200 rpm using deepgroove ball bearings.

The shaft shown in Figure P11-4 was designed in Problem 10-19. For the data in row (a) of Table P11-1, and the corresponding diameter of shaft found in Problem 10-19,….

Find the minimum film thickness for a long bearing with the following data: 30-mm dia, 130 mm long, 0.0015 clearance ratio, 1 500 rpm, ISO VG 100 oil at 200°F, and supporting a load of 7 kN.

1.       A paper machine processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50-m OD X 22-cm ID X 3.23-m long and is on a simply supported, 22-cm OD, steel….

Find the minimum film thickness for a bearing with these data: 30-mm dia, 25 mm long, 0.0015 clearance ratio, 1 500 rpm, ON = 30, ISO VG 220 oil at 200°F.

1.       Problem 7-12 estimated the volume of adhesive wear to expect from a steel shaft of 40 mm dia rotating at 250 rpm for 10 years in a plain bronze….